Disposable, super-sensitive, powder-free nitrile examination glove for broad use.
Indications
The Ajsia G00113 Linear disposable examination glove is made of a powder-free, chlorinated nitrile blend.
Recommended areas of use include healthcare, dentistry, and the cosmetics industry. Suitable for contact with food and compliant for use in the processing and production of foods based on grains and starch products, in the meat and meat product slaughtering industry, in the fruit and vegetable processing and production industry, and in the Horeca sector.
Directions for use
Wear the gloves on clean, dry hands free of rings, bracelets, watches, piercings, etc., so that the glove fits snugly around the fingertips and palm without the risk of superficial lacerations. To determine the correct glove size, consider that it should not be too tight or too loose.
Procedure for Removing Contaminated Gloves
- To begin removal, grasp the palm of your non-dominant hand and pull the glove out.
- Slide your hand out and hold the empty glove in the hand that still has the glove. Do not touch the glove with your bare hands.
- Now slide the index finger of your bare hand to the underside of your other wrist, inside the contaminated glove, being careful not to touch the outside of it, and pull the glove over the glove in your hand.
- Dispose of in the appropriate container.
- Wash your hands thoroughly, possibly with disinfectant soap.
Warnings
This information does not reflect the actual duration of protection in the workplace or the differentiation between mixtures and pure chemicals.
The chemical resistance was evaluated under laboratory conditions from samples taken from the palm only and refers to the chemicals tested. It may be different if the chemical is used in a mixture. It is recommended to verify that the gloves are suitable for the intended use because workplace conditions may differ from the test depending on temperature, abrasion, and degradation.
If used, protective gloves may provide reduced resistance to hazardous chemicals due to changes in physical properties and significantly reduce the effective use time. For corrosive chemicals, degradation may be the most important factor to consider when choosing chemical-resistant gloves.
Before use, check that the glove is in good condition: there are no cuts, holes, cracks, etc. If these conditions are not met, immediately replace the PPE/DM. The glove must be used only for the risks covered by this information note and alterations to the certified configuration are not permitted. If used as a medical device in a Non-Sterile field, it must be used temporarily if used invasively, in relation to the natural orifices of the body. It must not be used in contact with open vessels or in a surgical field or inside non-natural orifices of the body or where sterility is required. of the device.
The information note must be kept for the entire duration of the PPE/DM in use.
Once opened, the package must be protected from direct exposure to sunlight and fluorescent light.
The gloves are packaged in cardboard boxes.
The gloves must be stored in their original packaging, in a clean and dry place, protected from excessive heat sources (> 30°C) and direct sunlight. The user is advised to check the integrity of the glove before putting it into use. The glove must be used in its intact packaging and in the storage conditions indicated on the packaging, no later than the expiration date indicated on the packaging.
Gloves must be replaced after use as they are "disposable" and therefore cannot be subjected to maintenance, washing, or reuse.
Storage
Store protected from light, in a cool, dry place.
Shelf life in its intact packaging: 60 months.
Size
Pack of 100 gloves.
Product Code:FRCM237108
Richiedi info sul prodotto
